Plymouth Grand Voyager Speaker Size

Front Door Panel Speaker

Rear Door Panel Speaker

Plymouth Grand Voyager Speaker FAQ

What speakers should I replace first in my Plymouth Grand Voyager for better sound?

Replace the front door panel speakers first. Your Plymouth Grand Voyager uses 6 x 9 inch speakers in both front doors, and these handle most of your music's mid-range and vocal frequencies. Front speakers create the soundstage you actually hear while driving. The rear 6 x 9 speakers can wait - they're mainly for rear passengers anyway. Focus your budget on quality front coaxials first, then upgrade rears later if needed.

Should I choose component or coaxial speakers for my Plymouth Grand Voyager doors?

Coaxial speakers work better for most Plymouth Grand Voyager setups. Components give you separate tweeters and woofers, but you'd need to mount tweeters somewhere in the door panels or dashboard. That means cutting holes and running extra wires. Coaxials put everything in one 6 x 9 unit - tweeter built right into the woofer. Less installation hassle, and the sound improvement over stock speakers will still be significant. Unless you're planning a full sound system overhaul, coaxials make more sense.

Can I use full-range speakers in the rear doors of my Plymouth Grand Voyager?

Full-range speakers work fine in the rear position. Your Plymouth Grand Voyager's rear doors can accommodate full-range, coaxial, or component 6 x 9 speakers. Full-range might actually be ideal back there since rear speakers mainly provide ambient fill and bass support. They handle the entire frequency spectrum in one driver - typically around 40Hz to 20kHz. Less complex than coaxials, often more affordable. Just make sure they can handle at least 20-30 watts RMS to match your head unit's output power.

What power handling should I look for in 6 x 9 Plymouth Grand Voyager speakers?

Target speakers rated for 30-50 watts RMS power handling. Most factory head units in the Plymouth Grand Voyager put out around 15-20 watts per channel, but aftermarket units might push 25-35 watts RMS. Peak power ratings don't matter much - those inflated numbers like "200 watts max" are basically marketing. RMS is continuous power handling. Going too low means distortion when you turn up volume. Too high just wastes money since your amp can't use that extra capacity anyway.

Do 6 x 9 speakers in the Plymouth Grand Voyager need specific impedance ratings?

Stick with 4-ohm speakers for your Plymouth Grand Voyager. Most car audio systems expect 4-ohm loads, and that's what your factory setup probably used. You might find 8-ohm speakers, but they'll sound quieter since they draw less power from your amplifier. 2-ohm speakers exist but can strain some head units if they're not designed for low impedance loads. 4-ohm gives you the best balance - decent volume levels without overworking your amp. Check your head unit specs to be sure, but 4-ohm is the safe choice.