Tesla S Speaker Size
Speaker size, type, and location chart for Tesla S models from 2012 to 2021 production years.
As an Amazon Associate, we may earn a commission from purchases made through links marked. Read more in our disclaimer.
Front Speaker
| Years | Type | Size (inch) |
|---|---|---|
| 2012 - 2021 | Midbass / Full-Range | 6.5 |
Rear Speaker
| Years | Type | Size (inch) |
|---|---|---|
| 2012 - 2021 | Midbass / Full-Range | 6.5 |
Tesla S Speaker FAQ
What speakers should I replace first in my Tesla Model S for better sound quality?
Replace the front 6.5 inch speakers first. The front location gives you immediate improvement since you're sitting closest to them. Both coaxial and component options work in the Tesla Model S, but components separate the tweeter from the woofer. This typically means clearer highs around 3-8kHz. Front speakers handle most of your music's midrange frequencies where vocals sit, roughly 200Hz to 2kHz. You'll notice the difference right away compared to rear speakers.
Can I mix coaxial and component speakers in my Tesla Model S?
Yes, but keep the same type in front or rear pairs. You could run components up front and coaxials in back. The Tesla Model S accepts both 6.5 inch types in all positions. Components need separate tweeter mounting though - check if your car already has tweeter locations. Mixing might create slight phase issues around crossover points, usually 2-4kHz. Most people won't notice this. Keep impedance matching consistent, typically 4-8 ohms across all speakers.
Do component speakers sound better than coaxials in the Tesla Model S?
Components can sound better, but installation matters more than type sometimes. The 6.5 inch component setup separates frequencies better - tweeters handle everything above 3kHz while woofers focus on lower frequencies. This reduces interference. However, coaxials are simpler to install in the Tesla Model S since everything's in one unit. Good coaxials with silk dome tweeters can rival mediocre components. Your existing amplification affects this choice too - components might need more power, around 75-100 watts RMS versus 50-75 for coaxials.
What power handling should I look for in Tesla Model S replacement speakers?
Target 50-100 watts RMS for the 6.5 inch positions. The Tesla Model S factory system isn't incredibly powerful, so speakers rated around 75 watts RMS work well. Peak power ratings don't matter much - focus on RMS. Component speakers often handle slightly more power than coaxials due to separate drivers. If you're planning amplifier upgrades later, get speakers rated for 100+ watts RMS. Lower sensitivity speakers (85-88dB) might need more power but often sound more controlled than high sensitivity ones.